Here is Automotive Terminals Stamping Die Exporter talking about Stamping Die Installation Steps.
If you have any idea about Oem Stamping Services, welcome to contact us and discuss.
At present, many products are processed by stamping dies, but many of the friends do not stamp the mold installation steps when installing the stamping dies. Let's take a look at the installation steps of the stamping dies.
The general sequence of mold installation (referring to the mold with guide column guide):
1. According to the closing height of the Stamping Die, adjust the height of the slider of the press so that the distance between the bottom surface and the work surface of the slider at the bottom dead center is greater than the closing height of the stamping die.
2. Raise the slider to the top dead center, place the stamping die on the working surface of the press, and then stop the slider at the bottom dead center, then adjust the height of the slider so that the bottom plate is in contact with the plane on the die holder. The die with the die shank should be such that the die shank enters the die shank and the die shank is held by the clamps and screws on the slider. For large dies without mold shanks, the upper mold base is generally fastened to the press slide with screws or the like, and the lower mold base is initially fixed on the press table (without tightening the screws).
3. Then adjust the press slider to 3-5mm, start the press, narrow the stroke 1-2 times, stop the slider at the bottom dead center, and fix the lower mold base.
4. Carry out the test and gradually adjust the slider to the required height. If there is an ejector as above, the discharge bolt on the press should be adjusted to the required height.